Hello there! I have started revamping some buildings associated with The Battle of Waterloo. I have begun with Napoleons headquarters so that I can judge how best to do this work so that I can progress with the other buildings, Hougoumont and La Haie Sainte.
I started off with this. I started by stripping the doors and windows and removing the roof and end extension.
This gave me the bare bones of the foam board shell. Here I have added some depth to each end as I had completed the next step below.
I searched the internet for reference material. I found that some representations of this building had made a number of mistakes as there was a few differences to what the building looked like during the battle and after a number of changes had been made.
The sepia illustration above was the most accurate I could find which was contemporary with the battle. I was completed a few months after the battle.
The black and white picture is from Adkins 'The Waterloo Companion' That shows some smaller windows under the eaves which were a later addition. Lastly on the front facing the road the left hand doorway was bricked up. In most models it is a door.
There does not appear to be any detailed pictures of the rear of the building. There is a well and a separate building behind but this is not included in this work.
I obtained some graph paper and started a scale drawing with the reference information I had. I also needed to take into account the dimensions of the foam board model I had to work with and the spacing of the doors and windows to make them look right.
Once that was done I then photocopied the plans and glued them to a sheet of Canson Foamboard. This is a much higher quality foam board than what is available from the likes of Hobbycraft. It is denser and is sandwiched with two sheets of cartridge paper. It is much easier to peel of and leaved a clean area which can be impressed with brick much more easily.
The wider dimensions, between the above plan and the foamcore shell was different. The plan being much wider. I added some further width by cutting some cheaper foamcore board a little smaller than what was already there and glued them to each end. The final ends where cut in Canson foamboard so I could impress a brick end to it later.
This also gave me the final width for the front and back and ensured that it would all fit together with no overlapping.
As you can see above I have started to cut out the doors and windows. This gave me the opportunity top enlarge them, to suit 28mm figures more easily and take into account the thickness of the plasticard which will be the door surrounds.
Next I will fit the doors and windows
